Technical Data; Service / Warranty; Warranty Statement - Flymo 36V UltraStore 340R Operator's Manual

(27)
2. Unscrew the blade bolt
when applying force.
3. Remove the blade bolt (27)
(29)
4. Remove the blade .
(29)
5. Put the new blade on the mower.
(28)
6. Put the washer and the blade bolt
7. Screw the new blade (29) tight with the blade bolt
is 15 – 20 Nm. Do not over-torque.
8. Take care not to damage the spacer
that the screwdriver is removed before attempting to start the mower.
Problem Possible Cause
Engine is jammed and
Motor is blocked.
makes a noise
Cutting height is too low.
Loud noises, the mower Screws on engine, its fixing
is rattling or on the mower chasing are
loose.
Mower runs unevenly or Blade is damaged / worn
vibrates strongly or the blade mounting is
released.
Blade is very dirty.
Lawn is not cleanly mowed Blade is blunt or damaged.
Cutting height is too low.
Mower does not start Battery is empty.
or stops.
(L1)
LED is flashing green
[ Fig. O4 ]
Mower does not start Battery temperature is outside
or stops. the permissible temperature
(Wp)
Error-LED is illuminated range.
red [ Fig. O4 ]
There are drops of water or
moisture between the battery
contacts on the mower.
Motor is blocked.
Mower does not start Product is defective.
or stops.
(Wp)
Error-LED is flashing
red [ Fig. O4 ]
Mower does not start Battery is not put completely
or stops. into the battery holder.
(Wp)
Error-LED is not
illuminated [ Fig. O4 ]
Battery is defective.
Product is defective.
Charging is not possible.
The battery is not connected
Battery charge indicator (Lc)
(correctly).
is continuously illuminated
Battery contacts are dirty.
[ Fig. O3 ]
Battery temperature is out­
side the permissible charging
temperature range.
Battery is defective.
(Lc)
Battery charge indicator Mains plug of the charger is
is not illuminated [ Fig. O3 ] not (correctly) plugged in.
Socket outlet, mains cable or
charger is defective.
For any other malfunctions please contact the Husqvarna UK Ltd. Customer
Service. Repairs must only be done by Husqvarna UK Ltd. service departments
or specialist dealers approved by FLYMO.

7. TECHNICAL DATA

Battery Lawnmower Unit
Speed of rotation cutting
R/min
blade
8
22340-85.960.01.indd 8 22340-85.960.01.indd 8
. Take care not to damage the spacer
and the washer (28) .
(27)
on the mower.
(27) . Tightening torque
ä
when applying force. Make sure
Remedy
v Remove the obstacle.
v Raise the cutting height.
v Let the screws be tightened
by an authorised specialist
dealer or the FLYMO Service.
v Replace the blade.
v Clean the blade.
v Replace the blade.
v Raise the cutting height.
v Charge the battery.
v Wait until the battery tem­
perature is between
0 °C – + 45 °C again.
v Remove the water drops /
moisture with a dry cloth.
v Remove the obstacle.
Start again.
v Contact the FLYMO Service.
v Put the battery completely
into the battery holder until
it audibly engages.
v Replace the battery.
v Contact the FLYMO Service.
v Connect the battery to
charger correctly.
v Clean the battery contacts
(e. g. by connecting and
disconnecting the battery
several times. Replace the
battery if necessary.
v Wait until the battery tem­
perature is between
0 °C – + 45 °C again.
v Replace the battery.
v Insert the mains plug into the
mains socket (completely).
v Check the mains voltage.
Let the charger be checked
if necessary by an authorised
specialist dealer or the
FLYMO Service.
Value Value
Art. 9705386-xx / Art. 9705388-xx /
9705387-xx 9705389-xx / 9705390-xx
3,300 3,300
ä
Battery Lawnmower Unit
Cutting width
cm
Cutting height adjustment
mm
(5 positions)
Volume of grass box
l
Weight (without Battery) kg
Sound pressure level L
1)
dB (A)
pA
Uncertainty k
pA
Sound power level L :
2)
WA
measured/guaranteed
dB (A)
Uncertainty k
WA
Hand / arm vibration a
1)
m/s
vhw
Uncertainty k
vhw
Measuring process complying with:
NOTE: The stated vibration emission value has been measured according to
a standardised test procedure and can be used for comparison of one electric
power tool with another. It can also be used for preliminary evaluation of expo-
sure. The vibration emission value can vary during actual use of the electric power tool.
System Battery Unit
Battery voltage V (DC)
Battery capacity Ah
Number of cells (Li-Ion)
Appropriate POWER FOR ALL system Battery Chargers: AL 1810 CV / AL 1815 CV / AL 1830 CV /
AL 1880 CV.
Battery Charger Unit
AL 1810 CV P4A
Mains voltage
V (AC)
Mains frequency
Hz
Rated power
W
Battery charging voltage V (DC)
Max. battery charging
mA
current
Battery charging time 80 % /
97 – 100 % (approx.)
PBA 18V 2.0Ah W-B min.
PBA 18V 2.5Ah W-B min.
PBA 18V 4.0Ah W-C min.
Permitted charging
°C
temperature range
Weight according to
kg
EPTA-Procedure 01:2014
Protection class
Appropriate POWER FOR ALL system Batteries: PBA 18V.
8. ACCESSORIES
FLYMO System Battery Battery for additional duration or for
PBA 18V/45 P4A replacement.
PBA 18V/72 P4A
FLYMO Battery Charger Charger for the POWER FOR ALL system
AL 1810 CV P4A Batteries PBA 18V..W­..
FLYMO Replacement Blade As replacement for blunt blade.
for 36V UltraStore 340R
FLYMO Replacement Blade As replacement for blunt blade.
for 36V UltraStore 380R

9. SERVICE / WARRANTY

Service:
Please contact the address on the back page.

Warranty statement:

In the event of a warranty claim, no charge is levied to you for the
services provided.
Value Value
Art. 9705386-xx / Art. 9705388-xx /
9705387-xx 9705389-xx / 9705390-xx
34 38
20 – 60 20 – 60
35 45
10.8 11.9
75 77
3.0 3.0
86 / 87 89 / 90
0.7 1.0
0.7 0.6
2
1.5 1.5
EN 60335­2­77 RL 2000/14/EC / S.I. 2001 No.1701
1) 2)
Value (Art. 531382601) Value (Art. 531382701)
PBA 18V 2.5Ah W-B PBA 18V 4.0Ah W-C
18 18
2.5 4.0
5 5
Value (Art. 531382201)
220 – 240
50 – 60
26
18
1000
96 / 124
120 / 154
192 / 244
0 – 45
0.17
/ II
Art. 531382601
Art. 531382701
Art. 531382201
Art. FLY087 /
PNC: 599134690
Art. FLY099 /
PNC: 536119290
20.11.21 16:44 20.11.21 16:44