Kenwood DPX505BT Instruction Manual page 37

Installation/Connection
Part list for installation
(A) Round head screw ( ×6 )
( )
(C) Wiring harness ( ×1 )
Basic procedure
1
Remove the key from the ignition switch, then disconnect the
terminal of the car battery.
2 Connect the wires properly.
See "Wiring connection" on page 32.
3 Install the unit to your car.
See the following "Installing the unit (without mounting sleeve)".
4
Connect the terminal of the car battery.
5 Press B SRC to turn on the power.
6
Reset the unit. (Page 4)
Installing the unit (without mounting sleeve)
Align the holes in the unit (on both sides) with the vehicle mounting bracket
and secure the unit with supplied screws.
Use only the specified screws. Using wrong screws might damage the
unit.
(B) Flat head screw ( ×6 )
( )
Connect external components
No Part
1 Expansion port (12 V 500 mA):
To the optional SiriusXM Vehicle Tuner (commercially available) (Page 12)
2
Microphone input jack (Page 17)
3 Output terminals
REAR: Rear output
FRONT: Front output
SW: Subwoofer output
• When connecting an external amplifier to the output terminals of this unit, securely
connect the amplifier ground wire to the car chassis to prevent damage to the unit.
31
ENGLISH