Advertisement
2.1.
Controls and Connectors
2.2.
Handsfree Operation
When the telephone is inserted into the Holder, the antenna connection is made to the vehicle installed antenna. Connecting
the Handsfree connector into the telephone will divert the internal microphone and loudspeaker connections to the handsfree
loudspeaker and microphone units. Control of the loudspeaker volume will be maintained from the Handsfree unit.
The Handsfree unit will be activated when the vehicle ignition is ON.
The telephone can be used without having to remove it from the Holder, by speaking into the microphone and listening to the
speaker. If the mute option is connected, the car radio will be automatically muted during a call.
Operation of the telephone when installed in the Car Mount Kit is very similar to normal handheld operation but with the
following differences:
• Operation of the internal speaker and microphone of the telephone will be overridden by those of the Car Mount Kit.
• The Keep Alive timer will delay the switching off of the telephone when the vehicle ignition is turned off. Any calls in progre ss
when the ignition is switched off will be allowed to continue. The timer will not start until after the call is finished.
• When the Automatic Answer function is switched on, the call will be connected without pressing any keys.
• The ring volume cannot be turned off.
Adjusting the Speaker volume
Adjust the speaker volume by using the volume adjust the thumbwheel on the side of the Handsfree Unit.
Make sure that the vehicle ignition is switched on, the Battery Pack is attached to the telephone and that the Handsfree cable
is connected. Charging will commence immediately.
MCUK000201C8
Service Manual
Figure 2.1: Controls and Connectors
Section 2
– 3 –
OPERATING INSTRUCTIONS
Issue 1
Revision 0
Advertisement
