Kurzweil SP7 Grand Quick Start Manual page 7

GETTING STARTED GUIDE Rear Panel
SD Card Slot
The LCD touch screen firmware is updated using an SD card inserted into the SD card slot.
SW1 (Sustain) and SW2 Pedal Jacks
1) Use the SW1 (SUSTAIN) and SW2 jacks to connect switch pedals. One switch pedal is included
with the SP7 Grand.
2) In Sound mode, SW1 (SUSTAIN) defaults to controlling Sustain and SW2 defaults to controlling
Sostenuto. Pedal assignments can be adjusted for each zone by using Edit Mode.
Global Mode can be used to set pedal overrides, which can change the pedal assignments for all
sounds globally.
Note: Switch pedals must be plugged in before powering on the SP7 Grand. Do not step on the
switch pedals when powering on the SP7 Grand, as the state of the pedals is detected as part of the
startup sequence.
CC (volume) Pedal Jack
Use the CC (VOLUME) jack to connect a MIDI CC pedal (also known as a MIDI expression or volume
pedal). By default this pedal is assigned to control the volume (pre-FX).
The optional Kurzweil CC-1 continuous control pedal will work best with the SP7 Grand but it is also
possible to use third-party continuous control pedals designed for keyboards. Compatible pedals
should use a 10 kΩ linear-taper potentiometer, with a 1/4 inch tip-ring- sleeve (stereo) plug with
the wiper connected to the tip.
Main Out Jack (stereo)
Use the Main Out jacks to connect to a mixer or amplifier. When performing in mono, use the left
jack to connect.
Monitor Out Jack (stereo)
Use the Monitor Out jacks when connecting to an amplifier or speaker for monitoring.
Headphone Jack
Use the HEADPHONE jack located on the left rear panel of the instrument to listen to the SP7 Grand
on stereo headphones. You will need a 1/8-inch-to-1/4-inch adapter in order to use headphones
that have a smaller mini plug connector. When headphones are plugged in, audio is still transmitted
from the MAIN OUT jacks.
7