Advertisement
The design feature of our Heat Exchanger allows high pressure cold water to be heated in an
unpressurized tank. Cold water entering the heat exchanger passes through a coil submerged in heated
water. Electrical controls for the exchanger and pumping package are mounted on the outside of the
tank. The protective outer wrap and front panel enclose the controls.
After filling the water tank to the level indicated in Fig3, turn the heat exchanger switch to the "ON"
position. Once the heater has reached the set temperature, water may drip through a small hole in the
90 deg. elbow to prevent pressure from building up which can naturally occur when water is heated to
high temperature.
FIGURE 3
Heat Exchanger
Advertisement
