Table of Contents
Advertisement
Network Cables
Your network cables must have the following specifications:
N8406-037 10GBase-SR SFP+ module
Connector
Type of Cable
Cable Length
IMPORTANT:
-
-
-
-
-
-
-
-
-
N8406-039 1000Base-T SFP module
Connector
Type of Cable
Regulation
Cable length
(max.)
IMPORTANT:
LC Connector
Multi-Mode Fibre (MMF) cable
Core size: 50μm or 62.5μm
OM2 class
82m max. (when the core size is 50μm.)
OM3 class
300m max. (when the core size is 50μm.)
Only technically qualified personnel must install optical fiber cables. Contact
your service representative for cabling.
Handle optical fiber cables with care.
Be sure to allow for a 50mm minimum bending radius.
Do not force the cable connector into the slot. Align the connector at a right
angle. You can insert it smoothly if you align it properly.
Make sure that the surface of the optical fiber cable connector is clean and not
damaged.
To avoid mis-cabling, make sure that your cable meets the specification
required and that you connect the cable to a correct destination connector.
Do not drop the fiber optical cable. Do not allow the connector to make contact
with any surface, such as a floor.
Do not give any impact or pressure to the cable and its connector while it is
connected. To avoid damage to the cable, do not step on the cable or place
something heavy on it.
Do not force the cable connector into the slot. If you damage the end of the
cable, it may lower optical output and cause the cable to malfunction.
RJ-45
UTP/STP twisted-pair cable
Eight wicks, four pairs
1000Base-T
100m
This product supports 1000Mbps/Full Duplex only.
EIA/TIA standard
Category 5e or higher
(English)
29
Advertisement
Table of Contents
