Using The L75Ms; Wake From Standby; Selecting And Playing Sources - JBL L75ms Owner's Manual

Using the L75ms

Wake from Standby

The L75ms enters standby mode when the power button is pressed or after 10mins of no signal on a
selected source. To wake the L75ms from standby perform one of the following operations.
• Press any button on the remote or top panel.
• Connect to the L75ms via a Bluetooth or Wi-Fi Streaming Source.
• Power On device connected to L75ms via HDMI ARC

Selecting and Playing Sources

Sources may be selected directly by pressing the desired source button on the remote, using the source
selection button on the top panel, or automatically for Network or Bluetooth streaming and HDMI ARC.
Sources that can be automatically played will also wake the L75ms from Standby.
Using the Top Panel
Sources may be selected using the Source selection button located in the center of the top panel controls.
Pressing it advance to the next source to the right. The source will illuminate White when it is active.
Sources can also be selected directly using the buttons on the included RF remote.
Refer to Remote Control
A Streaming Sources
B Bluetooth
C HDMI-ARC
D Phono
E AUX
Pg 10 L75ms Owners Manual | Rev1.0 20220201 | Part No. 620-0595-001 | JBL.com/Specialty-Audio/
under Product Overview
Press to
Advance to
Next Source
Auto Switch - Selected when a device initiates a stream.
Auto Switch - Selected when a device connects via Bluetooth.
Refer to Connecting a Bluetooth Device
Auto Switch - Selected when a device connected to the HDMI input is powered
on.
Analog stereo from turntable.
Analog stereo via 3.5mm (1/8") TRS Stereo Analog.
for details.
on details to connect a device.