Advertisement
Page 6
SBBI-21-043-D
SERVICE CHECKS
Condition
Air escaping from port on regulator cap.
Pressure creepage registered on gauge.
Material tends to settle out rapidly.
Air bubbles form in material.
Air leakage at agitator seal assembly.
Paint getting into bearing assembly of agi-
tator.
Fluid or air leak at lid gasket.
Air motor siezed.
A. If agitator shaft does not turn by hand.
B. If agitator shaft turns freely, check
air motor.
Note: Occasionally check gauge (9). The needle should return to zero with no pressure on the gauge.
ACCESSORIES
PT-52-K10 & PT-52-K80 Liner. A molded
polyethylene tank liner to reduce tank clean
up time. The liner is made of tough, durable,
leakproof polyethylene and can be re-used.
May be used with all materials that are
compatible with polyethylene. (Available in
packages of 10 and 80 only.)
WARRANTY
This product is covered by Binks' 1 Year
Limited Warranty.
Binks Industrial Spray Equipment - www.binks.com
Binks has authorized distributors throughout the world. FOR INFORMATION OR THE DISTRIBUTOR NEAREST YOU, SEE
LISTING BELOW.
195 Internationale Blvd.
Glendale Heights, IL 60139
Cause
Broken or damaged diaphragm.
Dirty or worn valve seat in regulator.
Not enough agitation of material.
Material being over-agitated.
Defective seal assembly (50).
Paint level in tank too high.
Paint being over-agitated.
Defective seal assembly (50).
Defective lid gasket
Thumb screws not tight.
Damaged seal assembly (50).
Vanes (44) blackened/chipped at outer
edges due to lack of oil.
PT-413 Air Regulator Kit. Used to convert
single regulated tanks (fluid only), to dual
regulation (fluid and air). Used with portable
air compressors or with air lines when no
other means (air transformers or regulators)
of air pressure regulation is available.
Correction
Replace diaphragm.
Clean or replace valve seat.
Increase agitation.
Slow down agitator speed.
Optional QMS-79 propeller (see Accessories)
can be used to reduce the amount of agita-
tion.
Replace (50).
Fill tank 2-3" below rim.
Slow down agitator speed.
Replace (50).
Replace.
Tighten.
Replace (50).
Replace with Repair Kit KK-5001-1 and
refer to air motor agitator lubrication in-
structions.
Ball Valves. VA-542 air inlet shut-off valve.
To install, replace the 83-4233 D.M. nipple
with a bushing – 3/8(m) x 1/4(f) – purchased
locally. Attach ball valve.
VA-527 S.S. fluid outlet shut-off valve. To
install, remove the SSP-459 adapter. Using
these valves will simplify attachment of air
and fluid hoses.
QMS-79 Optional Propeller. Used with light
viscosity or waterborne materials where over-
agitation may be a problem.
Customer Service Toll Free
Technical Support
10/02
© Copyright 2002
1.630.237.5000
1.800.992.4657
1.888.992.4657
Printed in U.S.A.
Advertisement
