Advertisement
Installation steps:
1. Remove grease nipple from bearing.
2. Select the right size of adapter and accessories required.
3. Tighten seal tape on the outlet thread of the grease cup and
accessories.
4. Mount the adapter into the bearing's input hole, if necessary.
5. Manually tighten Easylube into the bearing or the adapter.
6. Put the protection casing back to the body.
Step 8.
Remote mount:
Caution:
Do not install the lubricator in ambient temperature over 60°C or on any
equipment with system pressure of 75 psi (5.2 bar) or higher. Always keep the
number of bends and the length of extension line to a minimum.
Important:
Always install the lubricator at a rigid and stable position.
Use copper piping hardware when the bearing temperature exceeds 50°C.
PU tubing harware can be used at bearing temperature lower than 50°C.
Installation steps:
1. Remove grease nipple from bearing.
2. Select the right size of adapter and accessories required.
3. Tighten seal tape on the outlet thread of the grease cup and
accessories.
4. Mount the adapter into the bearing's input hole.
5. Install the mounting bracket at a rigid and stable position.
6. Connect the piping or tubing between the bearing and the mounting
bracket.
7. Fill the connecting pipeline and the bearing with grease same or
compatible to the prefilled grease.
8. Manually tighten Easylube into the bearing or the adapter.
Tel .: +32 3 234 29 18 – Fax: +32 3 233 13 10 – Email: info@bondis.com
BONDIS bvba – Cleydaellaan 16/1 – 2630 Aartselaar – BELGIUM
ISO 9001:2008 n° 22714 – www.bondis.com
Advertisement
