Advertisement
Step 5.
Start Easylube:
► Install the battery back into the body assembly to start Easylube.
► The red indicator light on the body illuminates for 5 seconds and then
goes out. This indicates the lubricator has been started correctly.
► Screw the cover onto the body securely.
► Record the following on the cover label :
dispensing period setting
type of lubricant
date of installation
► After the start, Easylube will turn into "sleep" ode and the timer starts to count till each cycle
time is up for the dispensing.
Caution:
Every time the DIP switches are reset, the battery must be removed for approximately 15
seconds to clear the CPU memory.
Step 6.
Installation/ preparation:
► Flush the bearing and the pipeline completely with same grease
or compatible with that in the prefilled grease cup.
► The flushing process mustbe done slowly stroke by stroke to
detect any potential blocking in the pipeline or bearing. When a
power stroke is required to push the grease through, this might
indicate a jam or blockage..
► Feed the fresh grease into the bearing until the used grease is
completely purged.
Step 7.
Direct mount:
Caution:
If one of the folliwng conditions, please do not direct mount Easylube onto
bearings:
(1) The ambient temperatue is over 60°C.
(2) The bearing pipe thread is 6 mm, 1/16" or less.
(3) Bearings are in difficult to access areas or hazardous environment.
Tel .: +32 3 234 29 18 – Fax: +32 3 233 13 10 – Email: info@bondis.com
BONDIS bvba – Cleydaellaan 16/1 – 2630 Aartselaar – BELGIUM
ISO 9001:2008 n° 22714 – www.bondis.com
Advertisement
