BONDIS Easylube 150 Classic Service Manual

Easylube® 150 Classic –
Guide
Re-usable single-point automatic lubricator
Step 1.
Preparation:
► If you purchased empty grease cup, fill the cup with lubricant as below.
 Caution :
If the cup is being filled for the first time, the red piston must be pressed down to bleed air. Fill the
empty grease cup until the red piston reaches the top and in a level position.
Step 2.
Position the press plate:
► Facing the bottom of the body assembly, turn the press late clockwise until it seats.
► Next, rotate the press plate counterclockwise with a ¾ turn.
► Screw the prefilled grease cup into the body assembly securely and make sure the press plate
touches the red piston in the cup. If done properly, a small amount of grease is supposed to
discharge when the cup is securely screwed in.
 Caution :
Falling to engage the press plate and the red piston will disable the piston movement and result
in zero grease output after start-up.
BONDIS bvba – Cleydaellaan 16/1 – 2630 Aartselaar – BELGIUM
Tel .: +32 3 234 29 18 – Fax: +32 3 233 13 10 – Email: info@bondis.com
ISO 9001:2008 n° 22714 – www.bondis.com
Service