GE WCVH4800KWW Owner's Manual & Installation Instructions page 7

49-90369-2_ENv01:49-90340 ENv05 8/2/2011 7:37 PM Page 7
7
8
9
10
11
Signal
When the light is "on," the washer will
beep at the end of the cycle and every
time you press a button on the control
panel.
Extra Rinse
Use an extra rinse when additional
rinsing is desired to remove excess dirt
and detergent from soiled loads.
Delay Start
Use to delay the start of your washer.
1. Choose your wash cycle and any
options.
2. Press DELAY START button. You can
change the delay time in 1-hour
increments (up to 18 hours) each time
you press the DELAY START button.
Stop pressing the button when your
desired time is displayed.
3. Press the START/PAUSE button to start
the countdown.
The countdown time will be shown in the
ESTIMATED TIME REMAINING display.
Lock
You can lock the controls to prevent
any selections from being made. Or you
can lock or unlock the controls after
you have started a cycle.
Children cannot accidentally start
the washer by touching pads with
this option selected.
To lock the washer, press and hold
the TEMP and SPIN buttons together
for 3 seconds.
My Cycle
To save a favorite cycle, set the desired
settings for wash cycle, soil level, spin
speed and wash temp settings and
hold down the MY CYCLE button for
3 seconds. A beep will sound to indicate
the cycle has been saved.
To use your custom cycle, press
the MY CYCLE button before washing
a load.
To change the saved cycle, set
the desired settings and hold down
the MY CYCLE button for 3 seconds.
GEAppliances.com
To turn the signal off, press the SIGNAL
button and the light will go off.
NOTES:
n If the door is opened while the washer
is in DELAY, the countdown time will
continue to count down the delay
time. If the door is not closed and the
countdown time expires, the cycle will
not start until the door is closed and
the START/PAUSE button is pressed.
n You can delay the start of a washer
cycle up to 18 hours.
The light on the button will light up when
DELAY START is on.
To unlock the washer controls, press
and hold the TEMP and SPIN buttons
together for 3 seconds. A sound is
made to indicate the lock/unlock
status.
The control lock icon on the display will
light up when it is on.
NOTE: The POWER button can still be
used when the machine is locked.
NOTE: When using MY CYCLE,
wash options cannot be modified
after the cycle has been started.
NOTE: If you change wash options
with MY CYCLE before starting the cycle,
the MY CYCLE light will turn off and you
will be returned to the base cycle.
7