FANATEC CSL Elite V2 Manual page 21

Pedals

Table of Contents

Automatic Mode

In 'Automatic Mode', the automatic calibration sets a new maximum for the throttle

and clutch when each pedal is pressed beyond the default value and held for

approximately 2 seconds.

Manual Mode

Reset Calibration

By enabling 'Manual Mode', the minimum and

maximum values of each pedal can be manually

set throughout the mechanical travel range of each

pedal.

Example: Press the clutch pedal to the desired

lower travel range for when you want the signal to

start, then select 'Min'. Press the clutch pedal to the

desired upper travel range for when you want the

signal to reach 100%, then select 'Max'.

NOTE:

For 'Min' values there should always be a

minimum force applied that is at least equal to the

weight your foot resting on the pedal plate. Not

doing so may result in ghost inputs.

BRF (Brake Force) acts as the maximum value

setting for the load cell brake and is accessible via

the wheel base Tuning Menu as well. The brake

'Min' and 'Max' / 'Min' options for the other pedals

are only accessible via the Fanatec Control Panel.

By selecting 'Reset Calibration', the minimum and

maximum values of each pedal will be reset to the

default values.

NOTE:

Do not press the pedals during a reset.

Table of Contents