3-2. Connection Diagram
※ Only use the included power harness cable when supplying power to a camera.
3-2-1. HD-SDI Input
•
Connect to HD-SDI camera / output the power to camera using power over coax feature. (Input data
bitrate: ~3G)
•
Outputs power (DC24V) to HD-SDI VP (Video + Power) camera or HD-SDI VP device
3-2-2. HD-SDI Loop through Output
• Output the HD-SDI signal input from the HD-SDI camera (Output data bitrate: ~3G)
3-2-3. Analogue Video Input
•
Connect to Analogue Camera
•
Output the power (DC12V/500mA) to camera using power over coax feature.
•
Using Coax communication feature (Coaxitron), it is possible to control the camera OSD menu or a
PTZ Speed Dome camera via coaxial cable.
3-2-4. Analogue Video Loop Through Output & Pattern Signal Output
•
When Pattern Out is OFF, V.OUT port outputs the video received from Analogue camera.
•
Select Pattern Out ON, V.OUT port outputs Full Colour Bar to check the wiring status, monitor, DVR,
etc.
3-2-3. VGA Input
•
Connect to DVR or Computer and UXGA is supported at maximum resolution; higher resolutions may
not be displayed normally.
3-2-7. HDMI Input
•
Connect to DVR, Computer or other device which outputs HDMI signal. (Resolution: ~1080p 60Hz)
Hybrid Portable Test Monitor
9