Picture Set - Genie SDI07HY User Manual

3-2-4. PTZ & OSD Control Through RS-485
• Connect to PTZ Receiver and/or Speed Dome Camera as a controller. Also, connect to controller as
a PTZ receiver to check if the controller outputs data accurately.
※ Power over coax feature (Video+Power) for HD-SDI & Analogue VP camera and VP
transmission devices.
• Using the Power Over Coax feature of the Hybrid Test monitor, it's possible to supply power to VP
(Video+power) analogue and HD-SDI cameras via coaxial cable.
• POC (Power Over Coax) feature for HD-SDI VP camera (Optional): When it's necessary to
use the Power POC (Power Over Coax) feature, for installation and maintenance of a HD-SDI VP
camera or other HD-SDI VP Transmission product, press and hold the 'Enter' key for 3 seconds or
more, and the VP feature is activated; after detecting if the device automatically supports the POC
feature.
• Power Over Coax feature for Analogue VP camera (Optional): When it's necessary to use the
Power POC (Power Over Coax) feature, for installation and maintenance of an analogue VP camera
or other VP Transmission product, press and hold the 'Enter' key for 3 seconds or more, and the VP
feature is activated; after detecting if the device automatically supports the POC feature.
4. Menu Setting
4-1. MENU Mode
4-1-1. SELECT MENU
• Press MENU Button and main menu is displayed, as shown below.
• Press the directional buttons to move Up , Down , Right or Left .
The menu mode is automatically switched off if you don't press any buttons for a few minutes.

4-1-1-1. PICTURE SET

10
Hybrid Portable Test Monitor