Table of Contents
Advertisement
•
Contrast: To adjust the contrast range (0~100 steps)
•
Brightness: To adjust the brightness (0 ~ 100 steps)
•
Hue: To adjust the colour (0 ~ 100 steps)
•
Saturation: To adjust the chroma (0 ~ 100 steps)
•
Picture Mode: Standard > Movie > Vivid > User
The value of each mode changes automatically
•
Scale: To adjust the screen ratio (Full > 4:3 > Zoom1 > Zoom2 > 16:9)
•
Reverse: To reverse the upper and lower sides of the LCD screen.
4-1-1-2. ANGLE MODE
Indication lines: To adjust the viewing angles based on a specific area.
•
Selecting ANGLE MODE displays a green box and the camera angle zone indication lines.
•
Press the SET MENU button to select the size of the green box. Press the SET MENU button again
and select the side lines of the box you want to adjust, and press the / / / buttons to set
the position of each line.
•
To exit ANGLE MODE, press the EXIT KEY.
4-1-1-3. RS485 & COAX MODE (PTZ / OSD Control)
•
MODE: In RS-485 Tx and COAX mode you can control the PTZ & Camera OSD. In Rx. mode, it
receives the PTZ control data (as HEX values) and displays the data on the monitor. In Analyser
mode, it analyses the protocols received through the RS-485 port and displays the HEX value and
command.
•
PROTOCOL: To select the protocol of the equipment which you want to control.
•
ADDRESS: To select the address of the equipment which you want to control.
※ In COAX mode, you can control the camera regardless of the address
•
BAUDRATE: To select the communication speed (2400, 4800, 9600, 19200, 38400).
※ In COAX mode, you can control the camera regardless of the baud rate
•
START: To start controlling the device after setting all the above menus.
•
EXIT: To exit from MENU MODE
Hybrid Portable Test Monitor
11
Advertisement
Table of Contents
