Table of Contents
Advertisement
4-1-1-4-1. RS-485 (TX)
•
Displays the current setting mode at the top of the screen.
•
Press SET KEY in MULTI WAY KEY selection to select PAN/TILT or ZOOM/FOCUS mode.
- RED: P.T.Z MODE - BLUE: OSD MODE
•
Press the Mode KEY to select CAMERA OSD control mode.
•
Press the MENU KEY to control CAMERA OSD and press the ESC KEY to exit OSD MENU.
•
In case of BOX/DOME Camera, hold the ENTER KEY to select the OSD Menu.
•
Press EXIT KEY to go to the previous mode
•
(in CAMERA OSD mode, switch to PAN/TILT mode first, in order to exit).
•
Press / / / buttons following the OSD guidance on the screen.
※ Caution
•
The Hybrid Test monitor has two different PELCO-D Protocols, which are PELCO-D PROTOCOL,
PELCO (CNB).
•
For PELCO-D PROTOCOL, it is possible to enter the camera OSD menu by using MENU key.
(SET PRESET COMMAND)
•
For PELCO (CNB) PROTOCOL, it is possible to enter the camera OSD menu by using MENU key
(Go to PRESET) or ESC key (Run PRESET)
•
Depending on the camera manufacturer, the command to enter the camera OSD Menu is different.
4-1-1-4-2. RX
•
Displays the current setting mode at the top of the screen.
•
Displays the connection status of the RS-485 line indicated by a HEX value.
•
The received data via the RS-485 port is displayed as a maximum in 8 lines in bytes (16 byte).
•
When the data is more than 128 byte, it's cleared out automatically. You can also clear it out
temporarily, using the ESC button.
•
To go to the previous menu, press the EXIT button.
Hybrid Portable Test Monitor
13
Advertisement
Table of Contents
