Connecting To Joystick; Mounting Instruction (Transmitter-Joystick) - HOLMS 246564-005 Operating Instructions And Spare Parts List

Connecting to joystick

The functions on the transmitter may be connected to the
carriers manouvre unit for example the Joystick. This
requires a separate "connection pack" including contact
block and cabling (the connection pack has to be orderd
separate). A spring-back pressure switch is also needed
for each function.
To run the most frequent functions thru the Joystick use
the circuit diagrams special functions, see "Special
function 1 and 2" page 18.

Mounting instruction (transmitter-joystick)

1. Remove the inlet plugg from the transmitter.
2. Open the transmitter (4 screws on the rear).
3. Put the cable (from the connection pack) with the 4
conductors through the hole and mount the inlet.
4. Connect the power (any conductor) to the contact
block (see figure 5) connection number 9.
5. Choose functions according to diagram 7 and 8 (the
functions on the buttons are sorted by attachment).
6. Connect the other 3 conductors to the contact block,
use connection 1-8, see "Connecting
instructiononteringsanvisning (från sändare till
spakknopp (tillbehör))." page 18).
7. Mount the contact block on the circuit card in position
J1 (figure 6).
8. Mount the rear plate on the transmitter.
9. Make sure to tighten where the cable runs into the
transmitter.
10. Connect the conductors to the carriers Joystick
according to the diagram in figure 7 on page 18.
Check with the manufacturer of the carrier how the
connection to the joystick is done.
© HOLMS INDUSTRI AB, ALL RIGHTS RESERVED 170302.
Wireless control
5.Contact block with connection
(included in the connection pack)
6.Connection example with folding plough
17