Table of Contents
Advertisement
Wireless control
10
Description
The wireless control to run Holms attachments is divided
in 2 units. Transmitter and receiver. The transmitter is
mounted inside the drivers cabin close to the person
running the machine, it controlls the attachment thats
being used. The receiver is mounted on to the attachment.
The system is communicating wireless by radio, 2.4GHz.
The receiver scans all chanels and chooses the one with
less interuptions and directs the transmitter to it.
The receiver will save the latest transmitter that was
connected and will at start up try to connect to that one. If
that transmitter doesn't respond the receiver will search
for another avalible transmitter. I new transmitter may be
installed during a certain amount of time (20 sec). The
communication is controlled so that correct messages is
received with certain time interval. In case of
communication problems the transmitter is automaticly
set to go into safe mode.
© HOLMS INDUSTRI AB, ALL RIGHTS RESERVED 170302.
1.Transmitter
Advertisement
Table of Contents
