Wireless control
3.Transmitter
12
Connection
The transmitter will connect to the latest used receiver/
attachment.When a new receiver/attachment is used
make sure the latest receiver/attachment is shut down.
Connection receiver to transmitter
1. Connect the attachment to the carrier.
2. Connect the receiver to the carrier's electric outlet,
12V or 24V.
3. Connect the transmitter to the electric outlet inside the
cabin, 12V or 24V.
4. When the transmitter is ready for signal from the
receiver the diode lamp in button number 4 will blink
slowly.
5. When the transmitter is reciving the signal from the
receiver the diode lamp in button number 4 will blink
fast again. Confirm the connection within 20 seconds
by pushing button number 4.
6. If the connection is succesfull the diode lamp in
button number 4 will be on constantly and the the
attachment is now ready to be operated by the
transmitter.
Make sure the attachment is connected properly
and all the functions work according to the
manual/instruction before use.
© HOLMS INDUSTRI AB, ALL RIGHTS RESERVED 170302.