Turning Power On Or Off - Casio Privia PX-S7000 User Manual

Turning Power On or Off

1.
Before turning on the power, turn the volume knob to the position shown below.
2.
Press the P (Power) button to turn on the Digital Piano.
When the power is turned on, "Welcome" appears on the display.
• When the display changes to the top screen, the Digital Piano is ready to use.
• The time it takes for the Digital Piano to become ready to use depends on the internal memory
usage.
• Do not touch the pitch bend wheel when turning on the power.
• After pressing the P (Power) button, do not step on any pedals until the top screen appears.
• The Digital Piano may not turn on if the P (Power) button is pressed lightly, but this is not a
malfunction. If this happens, firmly press the P (Power) button again.
3.
Use the volume knob to adjust the volume.
4.
To turn off the Digital Piano, press and hold the P (Power) button for a moment.
• The light of the touch ring goes around once and goes out, and the message "Bye" appears on
the display.
• In its initial state, when the Digital Piano is turned on without the Wireless MIDI & Audio Adaptor
installed, the
that the Wireless MIDI & Audio Adaptor is not installed.
• Even after the power is turned off using the P (Power) button, the Digital Piano remains in standby
mode with a small current flowing through it. Always disconnect the AC adaptor from the power outlet
when the Digital Piano will not be used for an extended period or when there is a risk of lightning.
• When Auto Resume (page EN-17) is set to "Off", turning off the power will reset various settings, but
the Digital Piano still retains the following settings.
Tuning, LCD Contrast, pairing information (Bluetooth connection history), expression pedal type,
expression pedal calibration, Touch Button Sensitivity, Touch Ring Sensitivity, Operation Click
Volume, Auto Power Off, Wireless Notification Volume, Battery Type
indicator flashes briefly in the upper-right corner of the top screen to indicate
Top screen
EN-16
Overview and Setup