Troubleshooting - BOMANN VS 2195.1 Instruction Manual

Replacing the door hinge
If the appliance door starts to stutter, crack or jam
when you open it, it is probably due to a worn or
damaged hinge.
It is recommended to replace all door hinges at the
same time, otherwise the next repair will soon be
beckoning.
• Remove the contents of the appliance and the
movable interior parts.
• Tilt the appliance backwards and block it in this
position to prevent the door from sliding out.
• Loosen the appliance cover as described under
"Reversing the door opening"
the upper door hinge.
• Turn out the stand and disassemble the lower
door hinge.
• The respective hinge assembly is carried out in
reverse order.
• Open and close the appliance door for a test run,
readjust the hinges if necessary. In any case,
make sure that the door fits tightly and accurately.
Replacing the door handle
A malfunction due to too active use, may cause dam-
age to the door handle.
• Loosen the screw cover caps.
• Unscrew the screws underneath and remove the
door handle.
and disassemble
26
• The door handle is mounted in the reverse se-
"Assembling the door handle"
quence, see also

Troubleshooting

Before you contact an authorized specialist
Problem / Cause / Action
Appliance is not working properly or at all
- Check the power supply / temperature setting /
ambient temperature.
- Unblock the ventilation openings, install the ap-
pliance freely.
Loading is too warm
- Check the temperature setting / ambient temper-
ature.
- A large quantity of warm food has been stored in
the unit in the last 24 hours.
- The appliance door is not closed properly, check
the door seal.
Loud noise during operation
- Check that the appliance is level.
"Operating noise"
- See
Water on the appliance bottom
- Check the temperature setting / water discharge
channel or opening.
Light does not work
- Check the power supply.
"Changing the light"
- See
NOTE:
If a problem persists after following the steps above,
contact your trader or an authorized technician.
.
.
.