Table of Contents
Advertisement
Turning the Unit On
To turn the treadmill on, locate the ON/OFF power switch at the front of the treadmill and turn it ON.
Stride Sensor Auto-Shutoff System
The Stride Sensor auto-shutoff system detects whether a user is on the belt/deck. If the user leaves the belt/deck
during a workout, the system is triggered and the following message is displayed, User not detected on belt -
press "OK" to continue workout. If the user presses OK during this message the workout will continue without
interruption. If the user does not press OK another message will be displayed, User not detected on belt;
RESUME WORKOUT / EXIT WORKOUT. At this point power to the belt will shut off as the treadmill enters Pause mode.
If the user presses RESUME WORKOUT during the second message the workout will be resumed. If the user does not
press RESUME WORKOUT, the treadmill will continue in Pause mode and eventually end the workout. This feature can
be disabled in the Manager's Configuration.
Cable TV Hook-Up
The console can receive both analog and digital signals. Life Fitness is not responsible for the installation of CATV
service or components required for the delivery of CATV service. An external TV signal input via a 75-ohm coaxial
cable must be present before TV setup can occur.
Note to the CATV Installer: This reminder is provided to call the CATV system installer's attention to Article 820-40 of
the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be
connected to the grounding system of the building as close to the point of cable entry as practical.
Page 10 of 35
Advertisement
Table of Contents
