Features Of Electronic Control System; First Use - Teba therm T-30 Installation Manual

5.3 FEATURES OF ELECTRONIC CONTROL SYSTEM

1 - Electronic control system is a system that allows you to make the heat
control of your boiler comfortable and at the same time, eliminate problems
that may arise from low and high heat of the boiler and installation.
2- Due to the LCD display, it provides instant monitoring of the boiler
temperature, pump and fan operating status.
3- Since the circulation water in the boiler is no longer the highest limit
value of the circulation pump, the circulation pump continues to operate
and minimizes boiling, even if the heating water exceeds the boiling
temperature. As a result, the installation and the boiler are protected
against excessive expansion.
4- When the boiler temperature falls below +5 C in extreme cold conditions,
the circulation pump activates and does not allow any freezing in the
installation and boiler through circulating the heating water inside the
boiler and the installation.
5- In case of a malfunction of the temperature sensor, the circulation pump
activates automatically.

6. FIRST USE

1 - After completing the installation process of the solid fuel boilers, heating
water needs to be added to the boiler and radiators. While adding, the
water level could be monitored from the left side of the expansion tank. The
water needs to be filled half way. Check whether there is any leakage.
2- If there is no leakage in the installation, the 2 sockets (small) should be
removed. Plug in the power plug to activate the circulation pump. Run it
for 5-10 minutes in this position to remove the air gaps in the boiler. After
10 minutes, remove the power plug and re-insert the 2- sockets (small) and
plug the electric cable again.
9