Chengdu Ebyte Electronic Technology Co.,Ltd.
7.2.10 Set NMEA output
Command: 147
Set NMEA output baud rate;
Arguments:
Arg1:
9600,19200,38400,57600,115200......921600,
Example:
$PGKC147,115200*06<CR><LF>
7.2.11 GPD document delete
Command: 047
Delete GPD doc in flash
Arguments:None
Example:
$PGKC047*2C<CR><LF>
7.2.12 Set NMEA serial port parameter
Command: 149
Set NMEA serial port parameter
Arguments:
Arg1:
"0",NMEA data
"1",Binary data
Arg2:9600,19200,38400,57600,115200......921600,
Example:
$PGKC149,0,38400*2C<CR><LF>
$PGKC149,1,115200*15<CR><LF>
Remarks: This command is usually used in AGPS to load GPD files into Flash; the baud rate modification requires firmware version 3.0
or above to support configuration;
7.2.13 PPS configuration
Command: 161
PPS configuration
Arguments:
Arg1:
"0",turn off PPS output
"1",first time fix
"2",3D fix
"3",2D/3D fix
"4",always on
Arg2:
PPS pulse width(ms)
Arg3:
PPS pulse period(ms)
Example:
$PGKC161,2,500,2000*0<CR><LF>
Note: The maximum pulse width of PPS is 998ms, the minimum is 1ms, and the minimum range of pulse period is 1000ms.
7.2.14 Query message interval
Command: 201
Query interval for NMEA messagesArguments: None
Copyright ©2012–2021,Chengdu Ebyte Electronic Technology Co.,Ltd.
E108-GN User Manual
2 22