Using The Headphones - Silvercrest HG05014A Operation And Safety Notes

Using the headphones

Connect the headphones with a communication device.
Place the headphones near a switched on communication
device (e.g. mobile or computer).
Pairing with a new Bluetooth device: Hold the button
®
7
for approx. 3 seconds to turn on the product until the LED
4
flashes red and blue and acoustic signal sounds. This indi-
cates the headphones are now in pairing mode, which re-
mains active for 5 minutes. The headphones will switch off if
they do not detect a Bluetooth device to connect to and
®
acoustic signal sounds.
Now connect your communication device (mobile phone or
computer) via Bluetooth with the headphones. Please refer to
®
the notes in the instructions for your communication device. Se-
lect the entry "SBK 40 A1" from the list of devices detected by
your computer or mobile.
Once the connection has been established, the LED will
4
briefly flash blue twice every 3 seconds.
Please note, your communication device must support Blue-
tooth Standard 4.1 to use all options.
®
48 GB/IE