3-11 Ide Hdd Auto Detection - Intel BX User Manual

III. CMOS SETUP UTILITY
dialog box appears.
4. The system will ask you to confirm the new password by asking you to
type it in a second time. Carefully type the password again and press
ENTER, or just press ENTER if you are deleting a password that is
already installed.
5. If you typed the password correctly, the password will be installed.
[Note]
If you forget your password, or you want to cancel your password, you can do
the steps as the following,
(1) Password forgotten:
i> Turn off the system
ii> Short JP1 at Pin 2-3 for a few seconds to clear CMOS.
iii> Set the JP1 back to Pin 1-2.
iv> Power on the system.
(2) Clear Password:
Clear your password by key-in the password you installed before,
then go to PASSWORD SETTING to press ENTER twice.

3-11 IDE HDD Auto Detection

This item automatically detects and installs any hard disk drives installed on
the primary and secondary IDE channel. Most modern drives can be detected.
If you are using a very old drive that cannot be detected, you can install it
manually using the Standard CMOS Setup option. Setup will check for two
devices on the primary IDE channel and then two devices on the secondary
IDE channel. At each device, the system will flash an N in the dialog box.
Press Enter to skip the device and proceed to the next device. Press Y, then
Enter to tell the system to accept the BIOS auto-detected device type.
3-31