Resetting The Gsm Module By At+Cfun=1,1; Gsm 07.05 And 07.07 Commands - FALCOM I56 Hardware Description

I65/I56I HARDWARE DESCRIPTION

5.10.3 Resetting the GSM module by AT+CFUN=1,1

This command can only be used if the serial interface is enabled.
If the GSM software is still running, while the user feels the need to reset
the module, AT+CFUN=1,1 can be used. The module will properly be
logged-off from the registered network, resets and restarts the module to full
functionality. After reset and restart, PIN authentication is necessary
( + ). If autobauding is enabled, it is recommended to wait 3 to 5
AT CPIN
seconds before entering the first AT command.
The control status LED on SING pin (see section 5.8.2) shortly toggle to
OFF and back to ON again to show the progress.
Keep in mind that, the reset command described above, does not change the
level of I56/I56i functionality but only restarts the I56/I56i module.

5.11 GSM 07.05 and 07.07 commands

The GSM modem of the I56/I56i is controlled by an advanced set of AT
commands. For further information it is recommended to read the ETSI
GSM recommendation.
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.
See also related documents [4].
VERSION 1.00
Page 52