Advertisement
5-4
Keypad (Switch) section
5-4-1
Replacement
Fig. 10
Fig. 11
9
When assembling Main housing, put Keypad cable
(shown with green) in place as shown in the figure.
1
Disconnect Keypad cable from Control board
beforehand, and then replace Keypad (switch).
2
Keypad (Switch) is peeled off because it is glued
with an adhesive.
3
Remove the adhesive when assembling Keypad
(Switch).
4
When assembling Keypad (Switch), pass Keypad
cable through the hole (opposite of the arrow) as
shown in the figure in advance.
5
When assembling Main housing, put Keypad cable
in place and connect it to Control board as shown in
Fig. 10.
7 / 7
Advertisement
