Table of Contents
Advertisement
MAINTENANCE
Fuel is VERY flammable. Use extreme care when mixing, storing
or handling, or serious personal injury may result.
1.
Use a clean rag to remove
loose dirt from around fuel cap
and empty fuel tank.
2.
Pull fuel filter out through gas
port, and inspect fuel filter.
3.
Remove the filter from the line
and install the new filter.
Note: Federal EPA regulations
require all model year
2012 and later gasoline
powered engines
produced for sale in the
United States to be
equipped with a special low permeation fuel supply hose
between the carburetor and fuel tank. When servicing model
year 2012 and later equipment, only fuel supply hoses
certified by EPA can be used to replace the original
equipment supply hose. Fines up to $37,500 may be
enforced for using an un-certified replacement part.
Spark Plug
Level 2.
Parts Required: Tune Up Kit.
Use only NGK BPM7A spark plug (BPMR7A in Canada) otherwise
severe engine damage may occur.
1.
Remove spark plug and check
for fouling, worn and rounded
center electrode.
2.
Clean the plug or replace with a
new one. DO NOT sand blast to
clean. Remaining sand will
damage engine.
3.
Adjust spark plug gap by
bending outer electrode.
4.
Tighten spark plug to 150-170 kgf•cm (130-150 in•lbf).
38
SRM-410X
0.65 mm (0.026 in.)
X7502168400
© 11/20 ECHO Incorporated
Advertisement
Table of Contents
