Advertisement
HANGZHOU MINGHONG ELECTRONIC TECHNOLOGY CO., LTD.
Accessory
1. DeepVNA 101 host 4.3 inch (with screen protective film) × 1
2. USB-A to USB Type-C cable × 1
3. 20cm SMA male to male RG316 RF cable × 2
4. SMA male calibration kit - OPEN × 1
5. SMA male calibration kit - SHORT × 1
6. SMA male calibration kit - LOAD × 1
7. SMA-JJ male to male connector × 1
8. SMA-KK female to female connector × 1
9. SMA-JKW male to female right angle connector × 1
10. Quick Start Guide × 1
11. Foldable machine stand × 1
12. Resistive screen touch pen × 1
13. EVA protective bag × 1
Basic operations
Start a measurement
1. Set the frequency range (STIMULUS→START/STOP or CENTER /
SPAN)
2. Calibration (According to actual needs, refer to the next chapter)
杭州冥鸿电子科技有限公司 www.deepelec.com
3. Select display format and channel (DISPLAY→FORMAT/CHANNEL)
4. Save the parameters for the next measurement.
(CAL→SAVE→0/1/2/3/4)
You can change the display format and channel selection at any time.
In the normal test mode, tap the right area of the screen or press the
multifunctional switch to call up the menu. Tap the screen or turn the
multifunctional switch to select a menu item.
Select the display trace and display
format/channel
The menu DISPLAY → TRACE item can choose to open (activate) or
close the corresponding display curve. When the background color of
the curve name is consistent with the curve color, it indicates that the
curve is active. The items FORMAT, SCALE, and CHANNEL are only
valid for this curve. DISPLAY→SCALE can adjust the scale,
DISPLAY→CHANNEL can select the measured port.
Setting the frequency range
The frequency range of a channel can be expressed by three groups of
parameters: Start Frequency, Center Frequency and Stop Frequency.
If any of the parameters change, the others will be adjusted
automatically in order to ensure the coupling relationship among
- 7 -
Advertisement
