Advertisement
HANGZHOU MINGHONG ELECTRONIC TECHNOLOGY CO., LTD.
Note: If there is already saved calibration data, first press RESET to
clear the calibration data and then calibrate! If you make a mistake,
start again with RESET!
See more: www.deepelec.com/support
calibrate the touch screen
1) Enter menu CONFIG→TOUCH CAL
2) Use a toothpick or other sharp object to click the center of the cross
that appears in order.
3) CONFIG → SAVE .
Upgrade the firmware
Download & Points to: https://www.deepelec.com
0) Download and unzip the update. You should have a file update.bin
and update.all.
杭州冥鸿电子科技有限公司 www.deepelec.com
1) Connect your DeepVNA 101 to a PC's USB port using Type-C USB
socket on the device. Press the middle of the three way buttons and
keep it down, while powering up the device. The LCD displays the
following prompt, indicating that the boot-loader is active.
2) Then at PC side, the device will act as a disk drive, which should
appear in File Explorer. Copy you new "update.bin" and "update.bin"
into the root directory of that disk.
3) Power the device off and on, and the boot-loader will run
automatically, and update your DeepVNA 101. Re-power for normal
operation.
- 10 -
Advertisement
