Deck mounted 5-holes bathtub set with hand spray, goose neck spout (16 pages)
Summary of Contents for CANTERBURY Z3450
Page 1
• ¼ Turn valves handmade at Nicolazzi Factory • Lead Free Brass Compliant to AZ/NZS 3718 • Suitable even and uneven WM22315 pressure AS/NZS3662 Canterbury Sink & Tap Co. • Handles are interchangeable Max/Min Operating Pressure: 100/500kPa Further information Phone (03) 9761 4603 sales@sinkandtap.com.au...
Page 2
Important Notice Model : Z3450 CAREFULLY READ THROUGH THESE INSTRUCTIONS BEFORE INSTALLATION AND USE OF ALL TAP WARE AND WALL VALVES INSTALLATION and WARRANTY INSTRUCTIONS TECHNICAL INFORMATION All flexible hoses are designed and manufactured for use with water in exposed locations only. Do not expose to household cleaners, chlorine, chloride, hydrochloric acid or other corrosive chemicals.
Installation Instructions Model : Z3450 ❶ Preparation Flush out the pipework to remove any foreign matter. Tap cut out hole sizes : Maximum 40mm diameter. Under side clearance : Maximum 65mm ❷ ❸ Install the water supply hoses 3, into the ...
Page 4
Installation Instructions Model : Z3450 Feed the O-ring 5, over the water supply hoses. ❺ ❹ Install the supplied mounting stud 4, and Insert the tap into mounting hole. Feed the verify it is securely installed. water supply hoses carefully through the hole ensuring that they are not bent or kinked, as this could result in permanent damage or leakage.
Page 5
Installation Instructions Model : Z3450 ❽ Connect hot and cold water supplies to flexi tail hoses. Ensure all connections are firmly tightened. Before use Turn on the Hot and Cold supplies to the tap. Maximum temperature for Hot water supply to the tapware is 62 °C.
Page 6
Spare Parts list Model : Z3450 Further information Phone (03) 9761 4603 sales@sinkandtap.com.au...
Page 7
Care and Maintenance Instructions Model : Z3450 Removing and replacing a handle MODEL SHOWN : Z3450 Hand loosen the retaining flange A . ❷ ❶ Using a box cutter or similar sharp edged tool, carefully remove the indice button.
Page 8
Care and Maintenance Instructions Model : Z3450 MAINTENANCE FOR SINGLE HOLE/ADORE SINGLE LEVER TAP WARE WITH ONE LEVER DESIGN INSTRUCTIONS FOR REPLACEMENT OF THE C3009 CARTRIDGE See also:- https://youtu.be/mpdiKSEoznY Do not replace the cartridge if there is low flow or no flow. Low flow or no flow is caused by obstruction or kinking of supply hoses.
Page 9
Care and Maintenance Instructions Model : Z3450 LOW FLOW OR NO FLOW TROUBLESHOOTING INSTRUCTIONS Current kitchen taps have a max flow rate of 7 Litres per minute from the aerator and the hand spray. If you are experiencing low flow from the spout: Do not change the cartridge •...
Page 10
Care and Maintenance Instructions Model : Z3450 Care of external finishes Nicolazzi products are all authentic finishes that have not been coated with any product. After each use, pat the fixture down to remove any excess water. This will prevent any water spotting or mineral build-up. Use only soft liquid soap and water to clean the surface.