Makita DRC200 Quick Start Manual page 2

Operation
Check that the Robotic Cleaner is in standby mode.
1
Select the cruise mode and other settings, and begin
cleaning.
Cleaner
Operation
1. Select the cruise
mode.
The selected mode
2
lamp lights up.
2. Select vacuum
fan ON/OFF.
3. Select buzzer
volume.
4. Begin cleaning.
Note: The settings are maintained until the next time they are
changed.
Setting the auto-on start time
Check that the Robotic Cleaner is in standby mode before
setting the start time.
Setting the auto-on timer
1. Select the cruise mode.
2. Select the start time.
Remote
Cleaner
control
Auto-on
or
time
Pressing the button cycles
through the following
settings.
After
1 hour
After
3 hours
After
5 hours
Auto-on
timer
disengaged
Adjusting the buzzer volume
Perform the following operation in standby mode to set the
buzzer volume while cleaning.
Cleaner Remote control
or
Pressing the button makes the
buzzer beep and cycle through
the following settings.
High volume
Low volume
No sound (mute)
Note: For details, refer to the INSTRUCTION MANUAL.
All manuals and user guides at all-guides.com
Remote control
or
Pattern mode
↑ ↓
Random mode
See the front side of this sheet.
See below.
3. Activate the
auto-on timer.
Cleaner
Timer
lamp
Remote
or
control
The Robotic Cleaner
enters sleep mode, and
then starts cleaning
automatically when the
set time has elapsed.
Buzzer lamp on the
cleaner
Lights up
Lights up
Off
The Robotic Cleaner accepts the start operation and then
starts cleaning.
The buzzer beeps and the pilot
lamp flashes during cleaning.
To pause cleaning partway
Cleaner
3
After cleaning has been paused, press the Start/
Stop button on the remote control or the POWER
(start/stop) button on the Robotic Cleaner again to
restart cleaning in the same cruise mode as before
cleaning was paused.
When the battery power becomes low, the Robotic
Cleaner stops in place. Once the Robotic Cleaner has
been stopped for approx. 5 minutes, it automatically
enters sleep mode.
4
The Robotic Cleaner automatically turns OFF after the
following periods have elapsed.
When using two BL1830s: After approx. 60 hours
When using two BL1850s: After approx. 100 hours
Note: The time until the power turns OFF may differ depending on the
battery status, room temperature, and other factors.
Cruise mode
Cruise mode
Pattern mode For cleaning wide spaces with few obstacles.
(Ex.) well-organized warehouses, long corridors, etc.
Cleaning can be performed more efficiently by
starting the Robotic Cleaner from a position at the
closer end of the left wall.
Random mode For cleaning locations with many obstacles.
(Ex.) offices, etc.
Using the location-beacon feature
Press the Location beacon button on the remote control. The
Robotic Cleaner's buzzer will beep and the pilot lamp will flash,
helping you to locate the Robotic Cleaner.
The buzzer beeps for approx. 10 seconds
and the pilot lamp flashes.
Remote control
To stop the buzzer and flashing, press the Location beacon
button again.
Remote control
or
Description