Advertisement
NX-HD10
Disassembly method
<Main body section>
Removing the Top cover
1.
Remove the four screws A on the back of the body.
2.
Remove the screw B on each side of the body.
3.
Remove the rear side of the top cover upward as
shown in the figure while pulling both sides of the top
cover outward.
Removing the HDD board assembly
Prior to performing the following procedure, remove
the top cover.
1.
Disconnect the card wire from connector CN930 and
CN931 on the HDD board assembly on the right side
of the body.
2.
Remove the two screws C
screws D on top of the body.
3.
Release the joint
a
direction of the arrow. Move the rear side of the HDD
board assembly upward and remove.
C
Front panel
C
HDD board assembly
1-6
(See Fig.1,2)
(See Fig.3 and 4)
and the two special
on top of the body in the
D
Joint a
D
Fig.4
A
A
Fig.1
Front panel
Top cover
B
x2
Fig.2
HDD board assembly
CN931
Fig.3
Top cover
CN930
Advertisement
