JVC NX-HD10 Service Manual page 14

NX-HD10
<Front assembly section>
Prior to performing the following procedure, remove
the top cover, the HDD board assembly and the front
panel assembly.
Removing the Function switch board
1. Remove the two screws X attaching the bracket.
2. Remove the eight screws Y attaching the function
board.
Removing the Jack board
1. Remove the two screws Z
board toward the rear.
1-14
(See Fig.29~31)
(See Fig.31)
and pull out the jack
Bracket
Fig.29
Function switch board
Y
Y
Fig.30
Z
Fig.31
X
Function switch
board
Y
Jack board