Advertisement
switches are seen to go out. After this the heater will keep the air temperature in the room at the set
level by switching on and off automatically.
Fan Operation: - The fan will only operate with the thermostat in the "on" position and can be used
when the heating elements are "II" or "III" to blow warm air into the room.
PROTECTION AGAINST OVERHEATING
−
An additional fitted safety thermostat protects the heater against overheating and switches it off
automatically. The service lamp then goes out.
−
If the device switches itself off, disconnect the mains plug from the socket. The heater is ready
for service again after a short cooling-off phase (approx.15 minutes). Plug the mains plug back
into the socket.
−
If this repeats itself, first check whether the thermostat switch is set correctly or if objects
hinder the heating operation.
CLEANING THE HEATER
Always un-plug the heater from the wall socket and allow it to cool down before cleaning.
Clean the outside of the heater by wiping with a damp cloth and buff with a dry cloth. Do not use
any detergents or abrasives and do not allow any water to enter the heater.
STORING THE HEATER
When the heater is not used for long periods of time, it should be protected from dust and stored in a
clean dry place.
Note: this appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
When replacing old appliances with new ones, the retailer is legally obligated to take back your old
appliance for disposals at least free of charge.
Choose a suitable location for the heater, taking into account the
safety instructions above.
Insert the plug of the heater into a suitable socket.
Turn THERMOSTAT KNOB fully in a clockwise direction to the
maximum setting.
Turn on the heating elements by means of HEATER SWITCHES
on the side panel. Turn on the heating elements by means of
HEATER SWITCH on the side panel. You may obtain three
heating settings (750/1250/2000W) by turning the heater switch
knob in a clockwise direction.
When the desired room temperature has been reached, the
thermostat knob should be turned slowly anti-clockwise until the
thermostat is heard to click off and the lights on the element
Advertisement
