Jci1: Chassis Intrusion Connector; Jtpm1: Tpm Module Connector - MSI MAG X570S TORPEDO MAX Manual

JCI1: Chassis Intrusion Connector

This connector allows you to connect the chassis intrusion switch cable.
Using chassis intrusion detector
1. Connect the JCI1 connector to the chassis intrusion switch/ sensor on the chassis.
2. Close the chassis cover.
3. Go to BIOS > SETTINGS > Security > Chassis Intrusion Configuration.
4. Set Chassis Intrusion to Enabled.
5. Press F10 to save and exit and then press the Enter key to select Yes.
6. Once the chassis cover is opened again, a warning message will be displayed on
screen when the computer is turned on.
Resetting the chassis intrusion warning
1. Go to BIOS > SETTINGS > Security > Chassis Intrusion Configuration.
2. Set Chassis Intrusion to Reset.
3. Press F10 to save and exit and then press the Enter key to select Yes.

JTPM1: TPM Module Connector

This connector is for TPM (Trusted Platform Module). Please refer to the TPM security
platform manual for more details and usages.
Normal
(default)
1 SPI Power
3 Master In Slave Out (SPI Data)
5 Reserved
7 Ground
9 Reserved
11 Reserved
Trigger the chassis
intrusion event
2
12
1
11
2 SPI Chip Select
4 Master Out Slave In (SPI Data)
6 SPI Clock
8 SPI Reset
10 No Pin
12 Interrupt Request
Overview of Components
29