Assigning A Sensor To A Zone - GE 45131 User Manual

between the Magnetic Contact and the Sensor must
be no greater than ½". Once the plate is mounted,
use the doubled sided tape to attach Sensor to the
smooth surface of mounting plate. Be sure to position
the Sensor so that the side with the red marking is on
the same side as the Magnetic Contact.
Once the Sensor and Magnetic Contact are mounted,
you'll need to assign the Sensor to a Zone on the
Control Center.
Assigning the Sensor to a Zone
Assigning the Sensor into a Zone is an easy four step
process, however there are a few points to remember
- Only one Sensor can be assigned at a time.
- A Sensor cannot be assigned to two different Zones.
- Up to four Sensors can be added per Zone (if a fifth
Sensor is added then the first Sensor will be replaced.)
- Batteries must be active in the Sensor before it can
be assigned to a Zone.
- Sensors can be assigned to a Zone and then
mounted, or can be mounted and then assign to
a Zone.
Follow these steps to assign a Sensor to a Zone.
Step 1 – Press and hold the Learn button on the
Control Center for three seconds. When the
Control Center sounds a long beep, release the
Learn button.
Step 2 – Press the Zone button (1, 2, 3 or 4) for the
Zone you want to assign to the Window/Door
Sensor. The LED indicator for that Zone will
begin to flash.
8