Advertisement
7DEOH $ 3HULSKHUDO &RQILJXUDWLRQ 6XEPHQX 2SWLRQV
2SWLRQ
)XQFWLRQ
Parallel Port
Configures the parallel port. Set this option to Auto
(default), Enabled, or Disabled. Depending on the port
setting, you can set the following additional options:
Mode
If port is set to Auto or Enabled, available modes are Out-
put Only, Bi-Directional, ECP , and EPP .
NOTE: Refer to the device manufacturer's documenta-
tion for information on which mode to use before
changing this setting.
Base I/O
If port is set to Enabled, available I/O addresses are 378h
(default), 278h, 3BC, and 228h.
Address
Interrupt
If port is set to Enabled, available interrupts are IRQ7 and
IRQ5.
Audio
NOTE: This category is available in integrated-audio sys-
tems only.
Determines if integrated audio controller is Enabled
(default) or Disabled. Set to Disabled if using a sound
card instead of the integrated audio controller or if
resources used by the controller are needed.
)LJXUH $ ,'( &RQILJXUDWLRQ 6XEPHQX
FRQWLQXHG
System Setup Program
A-5
Advertisement
