Dell Dimension XPS R Series Service Manual page 52

Hide thumbs Also See for Dimension XPS R Series:

4-8

Dell Dimension XPS R xxx Systems Service Manual

)LJXUH 8SSHU ,QFK 'ULYH 5HPRYDO

5HPRYH WKH EH]HO

5HPRYH WKH GULYH FDJH DQG GULYHV DV DQ DVVHPEO\

5HPRYH WKH SODVWLF LQVHUW IURP WKH EH]HO

5HPRYH WKH

GULYH FDJH DQG WKHQ UHPRYH WKH EUDFNHW DV VKRZQ LQ )LJXUH

NOTES: The three screws used to secure the drive to the bracket and to

the left side of the drive cage have 3-mm threads. Be sure to use the cor-

rect 3 x 5-mm screws when you secure the drive to the bracket and the

drive to the cage.

Also note which screw was used to secure the drive bracket to the drive

cage in step 4, and use the same

bracket with its attached drive.

When you replace a drive, be sure to set the jumpers on the replacement drive

the same as the jumpers on the drive you removed. For additional information

about jumper settings on EIDE drives, see "EIDE Subsystem" in Chapter 1.

[

LQFK VFUHZ VHFXULQJ WKH GULYH EUDFNHW WR WKH

6/32

1/4

drive-bracket

mounting screw

screws for

drive assembly (3)

drive bracket

-inch screw when reinstalling the