Connecting A Pillow Speaker - Samsung 5 Series Installation Manual

You can connect a pillow speaker to the TV in the hospital using a jumper cable. The speaker functions as a remote control
and speaker.
Pillow Speaker
1. Connect the pillow speaker jumper cable (cable sold separately) from the television's
pillow speaker jack on the wall behind the television.
Pillow Speaker Jack Specifications
y Output jack: RCA type
y Input jumper pin: 1/8" 3-conductor stereo phone pin.
y Signal specifications: Tip-Audio, Ring-Data/Channel change, Sleeve-Common
Ring
Tip
How to Use the Pillow Speaker
y Analog type speaker: The pillow speaker has one key.
– Power On: press the key when the TV is in standby mode.
– Channel Up: press the key when the speaker is on.
– Power Off: press and hold the key for more than 3 seconds when the speaker is on.
– An Analog type speaker always works regardless of the Pillow Speaker Type value set in the Hospital mode setup
menu.
y Digital type speaker: The TV supports the Samsung, Philips, or Zenith code.
– This speaker is only compatible with a specified IR code. You can change the code in the Hospital mode setup menu.
– The TV gives priority to the Samsung remote control over the pillow speaker's wired remote control.
– Option : Channel Menu Display.
Pillow Sound Control
Speaker Selection Menu
TV Speaker
External Speaker
y Anynet+ function is not supported in hospital models.
8
English

Connecting a Pillow Speaker

Jumper Cable
Sleeve
VOL +
1
3
2
VOL -
TV Speaker
Sound
No Sound
TV Rear Panel
PILLOW SPEAKER Port to the
Pillow Speaker
Sound
Sound