Technical Data; Safety Instructions; Before First Use - BorMann BWR5118 User Manual

EN
WARNING! Read carefully and understand all ASSEMBLY AND OPERATION INSTRUCTIONS before operating.
Failure to follow the safety rules and other basic safety precautions may result in serious personal injury.

Technical data

Capacity:
Bed Opening:
Work Range:
Stroke Length:
Inside Bed Dimensions L x W:
Dimensions L x W x H:

Safety instructions

1. Study, understand, and follow all instructions before operating the device.
2. Do not exceed rated capacity.
3. Prior to use, make sure the press is securely anchored.
4. The press shall be installed and operated in accordance with instructions.
5. Ensure the work area is clean and free of any hazards before operation.
6. Keep hands, arms, feet, and legs out of the work area. Accidental slippage can result in personal injury.
7. Use appropriate guarding to contain any pieces that may break or fly apart when applying force.
8. Use only press accessories having a capacity rating equal to or greater than the capacity of the press.
9. Verify lift cables are slack before pressing on the bolster.
10. Avoid off-center loads.
11. No alterations shall be made to the product.
12. Do not use this press for any use other than the manufacturer specified usage.
13. Failure to heed and understand these instructions and markings may result in personal injury, property damage, or both.
Assembly instructions
Use the exploded drawing (Α) as your guide to assemble. Lay all parts and assemblies out in front of you before beginning.
The following procedure is recommended:
•Attach one base support (01) to left post and spreader (13) using bolts (12), washers (05), lock washers (04) and nuts (03), then attach another to right post
and the spreader.
•Fix one end of knighthead (06) to the base support (01) and another end to the post (08) using bolts (12), washers (05), lock washers (04) and nuts (03).
•Put the press frame in an upright position, attach one upper cross beam (30) to left and right posts (08) using bolts (12), washers (05), lock washers (04) and
nuts (03).
•Put another upper crossbeam into position and insert the jack fired seat(16) to the two upper cross beams at the same time, then secure this cross beam to
the posts using bolts (12), washers (05), lock washers (04) and nuts (03).
•Screw the upper round nut onto the ram (17), insert the ram into the hole in the jack fired seat (16), then screw the under round nut (15) onto the ram.
•Insert support pins (20) into the holes in the posts, then insert the joined press bed flat (21) into press frame and onto support pin.
•Attach the setting plate (24) to the right post using bolts (23), lock washers (04) and nuts (03), then secure the pump assembly using the screws (25) and
washers (26), then insert the handle to the handle bracket.
•Connect the hydraulic hose fitting (32) to the connection nut (31) and assemble the pressure gauge (19) to the pressure gauge connection nut (33) which is
on the top of ram (17).
•Tighten all bolts and screws.

Before first use

• Before first use of this product, purge away air from the hydraulic system: open the release valve by turning it counterclockwise. Pump several full strokes to
eliminate any air in the system.
• Check all parts and conditions, if there is any part broken, stop using it and contact your supplier immediately.
5
12 TON
80mm
0 ~ 920mm
175mm
80×500mm
770×500×1665mm
WWW.BORMANNTOOLS.COM