MAKEiD Q1-A HD Instructions

Under the environment with Electrostatic Discharge
Test Results the sample may be disconnected, but
it can be resumed to normal operation by user after
test.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired
operation.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. lf this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct
the interference by one or more of the followingme-
sures:
-Reorient or relocate the receivingantenna.
- lncrease the separation between the equipment
andreceiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV
technician for help.
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF
exposure requirement. The device can be used
in portable exposure condition without restriction.
Warning: Changes or modifications to this unit not
expressly approved by the part responsible for com-
pliance could void the user' s authority to operate
the equipment.
Chongqing Jingranyouxu Technology Co., Ltd.
Web: WWW.MakeID.COM
Q1-A HD
LABEL PRINTER INSTRUCTIONS