Page 1
Chongqing Jingranyouxu Science and Technology Co., Ltd. reserves the amendment right without further notice. Trademark MAKEiD is the registered trademark of Chongqing Jingranyouxu Science and Technology Co., Ltd. Microsoft is the registered trademark of Microsoft Corporation. Windows is the registered trademark of Microsoft Corporation.
Contents Foreword Disclaimer Safety Instructions 1.1 Overview 1.2 Unpacking 1.3 Packing List 1.4 Main Parts 1.5 Technical Parameters and Specification 3.1 Printer Operation 3.2 Description of Indicators 3.3 Connect a mobile device to operate the printer Chapter IV Maintenance 4.1 Preparation before maintenance 4.2 Cleaning of the Label Box Reader 4.3 Maintenance of Print Head 4.4 Cleaning of Internal Space...
• Do not use inferior label box (the ones not manufactured by MAKEiD), or the print head may be damaged and the service life of printer may be shortened. Damage of print head due to inferior materials is not included in the warranty range;...
Page 4
• To ensure the printing effect and avoid damage of print head, please do not use the printer at the environment with a temper- ature below 0℃ and a relative humidity over 80%. Meanwhile, when the temperature difference between indoor area and outdoor area is large, do not use the printer immediately after taking it into indoor area.
1.1 Overview D1 portable label printer is a smart, portable and interconnected label printer manufactured by Chongqing Jingranyouxu Science and Technology Co., Ltd. With MAKEiD APP, it can realize printing via mobile phone and tablet PC. 1.2 Unpacking After receiving the printer, check it carefully. In case of damage during transportation, claim against the carrier immediately. If there is no damage, check the accessories in line with the packing list.
Chapter II Installation 1.5 Technical Parameters and Specification Table 1-1 Specification and Parameters of Printer Function and Speci- Parameter fication Printing method Thermal transfer printing Paper detection Reflection-type mode Processor STM32F401 Resolution 178dpi Interface Type-C, bluetooth Effective printing 18mm width Maximum printing 15mm/s speed...
Page 7
Chapter II Installation 2.1 Installation of Label Box and Cautions 2.1.1 Check the label box and make sure that all parts are in good status and there is no breakage or other problems. 2.1.2 Insert the label box into the printer as shown in Figure 2-1. Close the printer cover. Figure 2-1 Installation Diagram of Label Box Please take good care of the environment.
Chapter III Printer Operation 3.1 Printer Operation 1. Power on the printer • Li-ion battery pack: 7.4V, 1200mAh • Power adapter Input: 5V 1A When the printer is turned on, the indicator indicates nothing after the adapter connected. When the printer is turned off, the lighting will flash after the adapter connected and it means the printer is not fully charged.
Chapter IV Maintenance Chapter IV Maintenance 4.1 Preparation before maintenance • Please read the “Safety Instructions” herein carefully before printer maintenance. • Use anhydrous alcohol with a concentration over 99% for cleaning. • Do disconnect the power supply before printer maintenance. 4.2 Cleaning of the Label Box Reader Dust and dirt is harmful to the contact between label box reader and label box sensing chip.
Chapter V Failure Treatment Chapter V Failure Treatment 5.1 Failure Indication Normally, when the printer is out-of-order or unusual, the printing will stop. Table 5-1 Printer Failure and Solutions Icon Description and Cause Solution The battery Connect the The battery is is running power for charge...
5.3 Failure due to other unknown causes For failure due to other unknown causes, please contact the Customer Service Dept. of MAKEiD. Telephone: 400-158-9100. Annex Please scan the QR code to get the link for installation of editing software. FCC STATEMENT 1.
Need help?
Do you have a question about the T1 Series and is the answer not in the manual?
Questions and answers