Wolf 24 E Series Installation Manual page 8

Installation
Electrical Connection
WARNING
Verify power is disconnected from the electrical box
before proceeding.
If the electrical supply is located in the opening, the elec-
trical connection must be made prior to placing the oven
in the opening. If the electrical supply is in an adjacent
cabinet, the electrical connection can be made after plac-
ing the oven in the opening.
1 Connect the black appliance wire to the black (L1)
power supply.
Connect the red appliance wire to the red (L2) power
2
supply.
Connect the green appliance wire to the green/ground
3
wire.
8 | Wolf Customer Care 800.222.7820
Installation
Place the oven in the opening and slide back.
Locate the mounting holes on the oven side trim, two on
each side. Drill 1/16" pilot holes. Use the provided mounting
screws to secure the oven to the cabinetry. Refer to the
illustration below.
To avoid interference, a 90° door stop may be required for
any appliance or cabinet door installed next to the oven.
CAUTION
Failure to install the mounting screws may cause the
oven to tip forward during use.
MOUNTING
HOLES
Oven installation