• Use only indoors on non-carpeted floor surfaces such as vinyl, tile, sealed wood, etc. Be careful not to run over loose objects or carpet edges. • Use only the battery pack and charger specified by the Proscenic. Using any other battery pack may cause personal injury and fire risk.
Page 5
Precautions FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Product Use Wall-mounted Charging Stand Installation Assembly 1. To assemble the handle, insert it directly into the appliance until you hear a click. 2. To disassemble the handle, use a tool (such as a screwdriver) to release the handle by pressingthe spring, and then lift the released handle from the appliance.
Page 9
Product Use Operation 1. Press the power button and the appliance 2. Press the function button to switch will start in SMART by default. Press it among SMART, MAX, Sterilization and again to turn off. Suction Modes. 3. Long-press the power button for 5s to 4.
Page 10
Product Use 7. When the appliance is charged on the charging base, you can press the self-cleaning button to automatically clean the roller brush and tube. After the self-cleaning, the Sterilization UV Light and fan will be turned on automatically after a delay of 5s.
Product Maintenance To get the best performance and prevent odors, thoroughly clean and dry the clean water tank, dirty water tank, filters, cleaning tool, roller brush and roller brush cover after each use. After maintenance, place the appliance vertically on the charging base and store them in a dry place indoors.
Page 12
Product Maintenance Roller brush self-cleaning 1. After use, put this appliance back to the charging dock for self-cleaning. Press the self-cleaning button to start the process. 2. After completion, you will hear the voice prompt “Cleaning completed, please clean the dirty water tank”. Note: Before self-cleaning, the battery level should exceed 20%, the dirty water tank should be emptied, and the water level of the clean...
Page 13
Product Maintenance Roller brush top cover 1. Grab the front handle while holding down the button, and pull up to remove it. 2. Wash it with water. 3. Make sure the cover is locked in place when installed, to avoid water leakage. click Roller Brush 1.
Install the filter; Clean the filter and tube The filter is dirty of the tube the motor is blocked. Error indicator flashes Shut down and restart after 2 minutes. If it still doesn't work, please contact the Voice prompt: Motor fault customer service: support@proscenic.com Fan error...
Product Specification Product model WashVac F20 Charging input 100~240V 21.6V, 4000mAh Voltage and electric quantity Rated power 200W Running time SMART: ~40min MAX: ~25min Charging time Water flow rate 45~200mL/min Clean Water Tank Capacity Dirty Water Tank Capacity 0.9L Water Resistant IPX4...
Page 16
Proscenic Technology Co., Ltd. (Authorized manufacturer) Shenzhen Proscenic Technology Co., Ltd. (manufacturer) Floor 8, Block A, building 5, Tusincere Park, Longcheng street, Longgang district, Shenzhen City, China Proscenic Technology INC. 36 South 18th Avenue Suite A, Brighton CO 80601 United States...
Need help?
Do you have a question about the Wash Vac F20 and is the answer not in the manual?
Questions and answers