INTRODUCTION The Clarion TVS5091 is a full-featured 5" LCD Color TV. It can be used as a stand-alone unit or integrated into a mobile multimedia system. ABOUT THE MANUAL AND W ARRANTY To start enjoying your new Clarion TVS5091, please read the instructions listed in this manual.
• Small black and shiny dots inside the liquid crystal panel are normal for liquid crystal products. PACKAGE CONTENTS The Clarion TVS5091 comes with the following items: • IR Remote Control • Car Stand •...
CAR STAND INSTALLATION 1. Choose the proper place to install. Make sure the surface is dry and clean. • If mounting on a flat surface, use a screwdriver to remove the two screws on the bottom of the stand to take away the support bracket. •...
REMOTE CONTROL BA TTERY INSTALLATION • Insert 2 AAA batteries into the compartment located on the back of the unit, following the polarities as shown. NOTES: • Each time you change the batteries, you must reprogram the unit. • We suggest you use alkaline batteries; do not use rechargeable batteries. •...
5. If the rod antenna is used, adjust the antenna direction to get the best reception. If unit is used in a vehicle, the Clarion ZCB301 Auxilliary TV Antenna is recommended to improve the reception. 6. Adjust the viewing angle. The recommended viewing angle of the TV unit is –...
FM antenna of the radio. 1. Place the FM Transmit switch to the setting “1”. 2. Turn the car radio ON and tune the FM dial to 88.7. The TVS5091 audio will now broadcast through the car’s audio system.
Page 9
Problem: No picture or sound on unit. Solution: • TV/AV1/AV2 mode may be selected incorrectly – Press the Input Selection button to the correct mode. • The TV and AV sources may be incorrectly connected – Check the connection and correct it. Problem: The picture is blurry and noisy.
Problem: Sound is poor with FM transmission (the TV sound through car audio system). Solution: • Make sure the FM transmitter is switched to setting 1 or 2 and the correct station for FM transmitter is set. (88.7 for setting 1 or 89.1 for setting 2) •...