Clarion VRX766VD Owner's Manual & Installation Manual page 24

Basic Operations
Mute
1. When in the TUNER, VISUAL or TV mode,
press the [p] button to turn the mute on
and off.
When in the DVD PLAYER, iPod or changer
mode, keep pressing the [p] button more
than 1 second to turn the mute on and off.
* When the mute is turned on, "MUTE" appears
at the bottom left of the screen.
Opening and turning the liquid
crystal panel
WARNING
• To prevent the battery from going dead,
operate this unit with the engine running
if possible.
• When the liquid crystal panel is
operating, be careful not to get your hand
or finger caught between the panel and
main unit or the instrument panel of the
car.
• Do not move the liquid crystal panel by
hand.
Standing up the liquid crystal panel
1. Press the [P] (OPEN) button.
The liquid crystal panel comes out and stands
up automatically.
The power of this unit will be turned on.
Note:
• If the liquid crystal panel stops in the middle of its
operation, press the [P] (OPEN) button to house
the panel and press the button again to raise it.
The unit will enter the same display mode as the
display was in when last turned off.
24
70˚
Panel calibration function
The liquid crystal panel's maximum angle of
inclination can be adjusted to match the
installation configuration within the automobile.
• Perform this with the panel in its closed
position.
1. Keep pressing the [P] (OPEN) button more
than 5 seconds.
The electronic beep will be heard.
After the beep sounds twice, the panel will
come out and stand up to the maximum angle.
After completion of the calibration, the panel
will be housed into the unit automatically.
* If the panel does not strike the instrument
panel or other parts of the car during
calibration, the maximum inclination will be
110°.
* If the panel strikes a car part during calibration
within a range of 70° inclination, the maximum
downward inclination will be 70°.