Sealey VS721.V2 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instruction protection
manual

1. SAFETY

‰
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this tool.
‰
WARNING! Familiarise yourself with the specific applications and limitations of this tool, as well as any potential hazards.
9
This tool should be used in conjunction with inspection maintenance procedures recommended in the vehicle manufacturer's manual.
9
Ensure that this tool is the correct tool for the task.
9
Ensure that the vehicle is properly supported with axle stands before working under the vehicle.
9
Ensure that there is adequate lighting prior to using this tool.
9
A range of inspection lamps are available from your local Sealey stockist.
9
Keep children and unauthorised persons away from the working area.
9
Keep the threaded rod well lubricated during operation to ease removal of bushes.
8
DO NOT use this tool for any purpose other than that for which it is designed.
8
DO NOT use air tools with this tool.
8
DO NOT use this tool if any parts are missing or damaged, as this may cause failure and/or personal injury.
8
DO NOT use this tool when you are tired, or under the influence of alcohol, drugs or intoxicating medication.
9
When not in use, store in a safe, dry location.

2. INTRODUcTION

Intended for the in-situ removal/installation of Vauxhall/Opel Vectra (95 -02) upper and lower rear trailing arm bushes. Bushes are quickly
pressed in or out with tool and a 19mm ratchet wrench (not included).

3. cONTENTS

Item Part no. Description
A VS721.V2-02 pressed support sleeve 55.5 x 54mm
B VS721.V2-01 pressed support sleeve 24.5 x 45mm
C VS721.V2-03 pressed support sleeve 20 x 45mm
D & F VS721.V2-06 Screw nut
E VS721.02-08 Thick spacer
G VS721.02-04 Threaded rod
ALWAYS KEEP THREADED ROD
WELL LUbRIcATED.
DO NOT USE AIR TOOLS.
© Jack Sealey Limited
bUSH INSTALLATION/REMOVAL KIT - VAUXHALL
VS721.V2
mODEL NO:
x
Threaded rod maximum load 150Nm. Exceeding this load will
shorten the life of the threaded rod. The threaded rod is
considered to be a consumable item and is NOT covered under
warranty.
Original Language Version
VS721.V2 | Issue:3 (H,F) 12/02/19